Jenn-Air JGS9900CDS Installation Instruction - Page 21

To Convert Gas Pressure Regulator 1. Remove access panel by grasping sides and pulling upward, lifting out. 2. Locate gas pressure regulator behind access panel. To Convert Oven Bake Burner 1. Remove oven racks from inside the oven cavity. 2. Remove the oven door. See "Oven Door" section in the Use and Care Guide for oven door removal instructions. 3. Using a Phillips screwdriver, remove and set aside the 2 oven bake burner cover screws located at the front of the oven. A A A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. 3. Unscrew the regulator cap and remove the plastic cover. A B A. Plastic cover B. Regulator cap 4. Flip the regulator cap over and replace the plastic cover. B A C A. Natural gas position B. LP gas position C. Plastic cover 5. Screw the regulator cap securely back into place. Do not overtighten. B A. Oven bake burner cover B. Oven bake burner cover screws 4. Lift up and remove oven bake burner cover. 5. Unscrew 2 wing nuts and remove oven baffle. A B A. Oven baffle B. Wing nuts 6. Using a Phillips screwdriver, remove and set aside the 2 oven bake burner screws and the orifice hood cover screw. B A C D A. Oven bake burner screws B. Orifice hood cover C. Orifice hood cover screw D. Oven Bake burner 7. Lift up and remove orifice hood cover. 8. Lift up and remove oven bake burner. 21