Jensen BT1611I Owners Manual - Page 25

BT1611i NOTE: When a call comes in during standby mode (ignition on/power off), the head unit will turn on automatically so you can accept/reject the call. NOTE: When a call comes in during talking mode, the OPEN/EJECT button (31) becomes deactivated. Answering an Incoming Call To answer the incoming call, press the AUDIO CONTROL (DIAL) button (3). NOTE: During an incoming call, the audio output is muted and a ringtone is played. CD play is paused. Use the AUDIO CONTROL (3) to adjust the volume during your phone conversation. During an active call, the LCD will display "Phone >>>>" followed by the the elapsed call time. To end the conversation, press the B (CLEAR) button (5). Rejecting an Incoming Call Press the B (Clear) button (5) to reject an incoming call. Making an Outgoing Call 1. Press the AUDIO CONTROL button (4) to begin an outgoing call. The LCD will dis- play and a cursor will blink while waiting for the phone number entry. 2. Turn the AUDIO CONTROL to select 0-9, *, and # to input the phone number, pressing the AUDIO CONTROL to confirm each selection. Press the B (CLEAR) button (5) to clear the last digit, or use the Up Tuning (14) or Down Tuning (13) buttons to move the cursor back or forward to the incorrect input digit and then press B. 3. After entering the phone number, press and hold the AUDIO CONTROL or press the MODE button (2) to dial the call. NOTE: The audio output will only be muted after the PHONE button is pressed to dial the outgoing call. NOTE: During an outgoing call or during talking mode, the OPEN/EJECT button (31) becomes deactivated. Use the AUDIO CONTROL (3) to adjust the volume during your phone conversation. To end the conversation, press the B (CLEAR) button (5). If the ignition is turned off during a call, the unit will remain on, allowing you to complete the call, until you press the B (CLEAR) button to turn the unit off. The unit will continue to operate on battery power until it is turned off. Call Transfer While talking, to transfer audio from the head unit back to the mobile phone, press the MODE (Transfer) button (2). The LCD will display for 3 seconds. • When making an outgoing call, it's not possible to transfer the call if it is not yet answered. You can only transfer a call after it has been answered. • The time it takes to transfer the call back to the phone will vary depending on your phone model. NOTE: The BT1611i can only handle one call at a time, two lines cannot be active at one time even if your phone has call waiting. 25