Kenmore 1776 Use and Care Guide - Page 15

Hi Temp Select this option to heat the water to 140°F (60°C) during parts of the cycle. Heating the water helps improve washing results. This option adds heat, water and wash time to parts of the cycle. Hi Temp wash is useful when loads contain tough food soil items. NOTES: • Pots Pans automatically uses this option. Hi Temp wash is an option with the Heavy Wash and Normal Wash cycles. • Use this option for heavier than normal-soiled loads. Heated Dry The Heated Dry option in combination with rinse aid will give you excellent drying results. The energy to use Heated Dry costs pennies per cycle. Heated Dry is on when the light is lit on the Heated Dry button. Be sure to load plastic items in the upper rack to avoid damage. You may turn off the Heated Dry option by pressing HEATED DRY so that the light goes off. However, you will have items in your dish load that will not be dry at the end of the cycle. NOTE: The Heated Dry option is used in all cycles except Quick Rinse. Lock On Use the Lock On to prevent unintended use of the dishwasher. You can also use the lock feature to prevent unintended cycle or option changes during a cycle. When LOCK ON is lit, all buttons are disabled. NOTE: The dishwasher door can be opened while the controls are locked. However, the lock must be turned off and the Start/ Resume button pressed to resume the cycle. To turn on the Lock Press and hold HEATED DRY for 4 seconds. LOCK ON glows. If you press any pad while your dishwasher is locked, the light flashes 3 times. NOTE: If the Heated Dry option is selected, the light will temporarily turn off until Lock On glows. To turn off the Lock Press and hold HEATED DRY for 4 seconds. The light turns off. Delay Hours Select this option to run your dishwasher at a later time or during off-peak hours. You can add items to the load anytime during the delay. After adding items, firmly close the door until it latches and press START/RESUME, or the delay will not continue. To delay the start 1. Press the delay button to choose the number of hours delayed. 2. Select a wash cycle and options. 3. Press START/RESUME. The dishwasher starts the cycle in the selected number of hours. NOTES: • To cancel the delay and cycle, press CANCEL/DRAIN. • To cancel the delay and start the cycle, press START/ RESUME. Follow the progress of your dishwasher with the Cycle Status indicators. Washing Drying Clean Clean CLEAN glows when a cycle is finished. The light turns off when you open the door or press Cancel/Drain. During drying, you can see steam escaping through the vent at the upper left corner of the door. This is normal as the heat dries your dishes. I _ II | I lit I• • "_ tI IMPORTANT: The vapor is hot. Do not touch the vent during drying. %j, 8#{1_,;1_ ,,._ ............ The overfill protection float (in the front right corner of the dishwasher tub) keeps the dishwasher from overfilling. It must be in place for the dishwasher to operate. Check under the float for objects that may keep the protector from moving up or down. 15