Kenmore 75062 Owners Manual - Page 8

D IF AIR CONDITIONER IS BLOCKED BY STORM WINDOW FRAME • If storm window presents interference, fasten a 2"(51mm) wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference from the the storm window frame. See FIG. 10. Top of wood strip should be approximately 3/4"(19mm) higher than the storm window frame to help condensation to drain properly to the outside. • Install a second wood strip (approximately 6"(152mm) long by 11/2"(38mm) wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill. (FIG. 10) 1 1/2" rnin. WOOD STRIPMOUNTED (38mm) 3/4"(19mm) CLEARANCE ON TOPO_ SILL o- , STORM _ WINDOW /J_/_ FRAME _/_V_/O/_/SS/T/_ INDO0_ //}/ OUTER _// SILL _// OUTDOOR When storm window frame is located on outer sill FIG. 10 D INSTALLATION FOR OTHER TYPE WINDOWS. • Dimensions and geometry of windows are different according to manufacturers. Check your window and refer to FIG.11 to install the support bracket firmly. (a) When window frame is located on inner sill, • Install a wood strip (window width long and window frame height high) on the inner sill. SASH WINDOW _-_ WINDOW FRAME _. WOOD STRIP O_ UTDOOR (b) When the window frame is higher than 19/32"(16mm) • Install a wood strip (about 4"(102mm) long) on the outdoor sill to raise support bracket, WINDOWFRAME_ 19/32"(1_ FWOODSTRtP 'NNFLR_ O_UTDOOR BILL FIG. 11 REMOVAL FROM WINDOW • Turn off and unplug the air conditioner. • Unscrew the side screws that you installed in Step 5.6. • Close the curtain frame and remove foam seal and L bracket from the windows. • Keep a firm grip on the air conditioner raise the sash. • Lift the air conditioner from the window and remove the foam strip from between the windows. • Remove the support bracket from window frame. NOTE: When cooling season is over, unit is removed from window for cleaning and storage. There may still be some condensation water in the basepan. Remove the unit carefully to avoid water being spilled out on floor, always store unit fiat on its base. Do not stand on end. Be sure to remove support bracket, L bracket, and foam seal from window and save. Window will not close if support bracket remains installed. • Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit. To prevent injury or strain, use proper lifting and carrying techniques when moving unit. • When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front and rear coils. • Make sure air conditioner does not fall during removal. -8-