Kenwood DDX7018BT Instruction Manual - Page 51
Wiring connection
![]() |
View all Kenwood DDX7018BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Installation and Connection Wiring connection For DDX7018BT/DDX7018BTM [ STEERING REMOTE ' *1 Gray/Red ST REMOTE GND Bright green/Red Input 1 Purple/Red Input 2 Connect to your vehicle's steering remote harness. Contact your KENWOOD dealer for details. Connect the antenna cord to the antenna terminal. 10 A fuse Purple with white stripe REVERSE Light green ¥ PRK SW White ] / White with black stripe [ Gray ] / Gray with black stripe [ Green ] / Green with black stripe [ Purple ] / Purple with black stripe [ Brown Orange with white stripe Light blue with yellow stripe Blue with white stripe (12 V 350 mA) Red (Ignition wire) MUTE ILLUMI STEERING WHEEL REMOTE INPUT REMOTE CONT ANT.CONT P.CONT Yellow (Battery wire) Black (Ground wire) USB input terminal (1 m) To the car's reverse lamp harness when using the optional rear view camera Extension wire ( ø ) To the car's parking brake detection switch harness (For best safety, be sure to connect the parking sensor.) To front speakers/mid range speakers*2 (left) To front speakers/mid range speakers*2 (right) To rear speakers/tweeters*2 (left) To rear speakers/tweeters*2 (right) *1 Only for DDX7018BTM. *2 For 3-way speaker system connection, see page 48. Not used. To the car light control switch To the OE remote adapter (not supplied) which is compatible with your car To the power control terminal when using the optional power amplifier (Or) To the control terminal of the motor antenna or to the power terminal for the booster amplifier of film-type antenna Ignition key switch Car fuse To the car chassis Car battery ENGLISH 49
![](/manual_guide/products/kenwood-ddx7018bt-instruction-manual-f7d0588/51.png)