Kenwood XD-355 User Manual 1 - Page 15

To interrupt playback : 1 Press the 8 button on the remote control. • "8" will light up. 2 Press the 3 button to resume playback from the same point. To stop playback : Press the 7 STOP button. To remove the CDs : Whilst in the stop mode, press the 0 OPEN/CLOSE button. • The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to rotate the disc tray and remove the remaining disc. After use : Press the ON/STANDBY button to enter the standby mode. Cautions : • Do not carry the unit with discs left in the disc trays. The disc may become loose inside the unit and they may be damaged or cause dam- age to the unit. This may also cause malfunc- tions. • Do not place two CDs in one disc position. • Do not push the disc tray whilst it is moving. • Do not attempt to turn the disc tray by hand. This may cause malfunctions. • If the power fails whilst the tray is open, wait until the power is restored. • If the disc tray is stopped forcibly, "ERR" will appear in the display and the unit will not func- tion. If this occurs, press the ON/STANBY button to enter the standby mode and then turn the power on again. • If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. • If a disc is damaged, dirt, or loaded upside down, the disc will be skipped and the next disc will automatically play. Disc number selection 1 1 When stopped, press the DISC SKIP button. 2 Press the 3 button. • The next disc playback will begin, after which each following disc will be played sequentially. 2 Notes : • When the DISC SKIP button is pressed during playback, playback will begin automatically from the next disc. (It is not necessary to press the 3 button.) • When one of the disc number buttons (DISC 1- DISC 3) is pressed during playback, playback of the selected disc will begin automatically. (It is not necessary to press the 3 button.) DISC 1 - DISC 3 1 2 15 EN