Konica Minolta MGI JETvarnish 3D One MGI JETvarnish 3D One User Manual - Page 23
Jetvarnish 3d One Specifications And Configurations
View all Konica Minolta MGI JETvarnish 3D One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
JETVARNISH 3D One 4 JETVARNISH 3D ONE SPECIFICATIONS AND CONFIGURATIONS 4.1 Machine specifications For the machines produced from September 2020 - S/N ≥ 141 MGI's exclusive inkjet engine technology Drop-on-Demand (DoD) technology Printing technology Konica Minolta piezoelectric inkjet printheads Single pass printing Varnish thicknesses Production speeds Flexible printing architecture Depending on your file, the printed material, the CYMK printing technology and/or finishing technology used, the coating thickness can vary from 21 µm up to 116 µm for 3D raised effects and a tactile finish. When activating the dithering mode, the varnish thickness can be as low as 7 µm, if the substrate permits. The minimum varnish thickness over toner (for KM Bizhub and MGI Meteor DP8700+ digital presses) is 36 µm in order to have optimum printing quality. Under certain conditions, this thickness can be reduced down to 21 µm when the CTS Corona module is installed and activated. LED#1 should be off and tested/validated applications and substrates should be used. Up to 2,077 A3 per hour at 21** µm Up to 1,468 A3 per hour at 43** µm **NOTE: Printing speeds are given to indicative information and may vary according to printing substrate, number of drops set on the data file and under full operator responsibility. See the above table to learn more Registration Formats Automated registration using MGI AIS SmartScanner system. Overall registration of ± 200 µm Min: 21.0 x 29.7 cm / 8 x 11.8". Feeding direction restriction applies on A4 paper size when the CTS Corona option is installed Max: 36.4 x 75 cm Max. print width 35.2 cm or 352 mm Min: 135 Gsm and not less than 150 µm after printing & lamination Substrate thickness Max: 450 Gsm and not more than 450 µm after printing & lamination Substrates UV coating container capacity Motorized height-adjustment print heads Printing on most matte or glossy laminated surfaces, with or without aqueous coating, layered paper, plastic, PVC and other coated materials Printing directly on most digital prints (i.e. Bizhub C1070/C1060, C1100/C1085, C3080, or Meteor DP8700+) with no lamination or coating required 10 liters/2.6 US gal. tank capacity Vacuum belt feeding system Automatic paper feeder Able to handle a paper pile up to ±28 cm high Paper exit tray All paper formats from A4 up to 36.4 x 75 cm Tray able to handle a paper pile up to 15 cm. Automatic tray full sensor All paper formats from A4 up to 36.4 x 75 cm User Manual - 23 -