LG BH200 Owner's Manual (English) - Page 21

Installation and Setup BH200-N_AUSALLK_ENG 4/18/08 9:28 AM Page 21 [AUDIO] Menu Each disc has a variety of audio output options. Set the player's Audio options according to the type of audio system you use. Note: Since many factors affect the type of audio output, see "The unit's Audio Output Specifications" on page 36 for details. Sampling Freq. (Maximum Sampling Frequency) [192KHz] - Select this if your A/V Receiver or Amplifier is capable of handling 192 KHz signals. [96KHz] - Select this if your A/V Receiver or Amplifier is NOT capable of handling 192 KHz signals. When this choice is made, this unit automatically converts any 192 KHz signals to 96 KHz so your system can decode them. [48KHz] - Select this if your A/V Receiver or Amplifier is NOT capable of handling 192 KHz and 96 KHz signal. When this choice is made, this unit automatically converts any 192 KHz and 96 KHz signals to 48 KHz so your system can decode them. Check the documentation for your A/V Receiver or Amplifier to verify its capabilities. HDMI / SPDIF (Digital Audio Output) Select the output sound format when a device equipped with an HDMI or Digital Audio input jack is connected to the HDMI OUT or DIGITAL AUDIO OUT jack on this player. [PCM Stereo] - Select if you connect this unit's HDMI OUT or DIGITAL AUDIO OUT jack to a device with two-channel digital stereo decoder. [PCM Multi-Ch] (HDMI only) - Select if you connect this unit's HDMI OUT jack to a device with multi-channel digital decoder. [DTS Re-Encode] - Select if you connect this unit's HDMI OUT or DIGITAL AUDIO OUT jack to a device with DTS decoder. [Primary Pass-Thru] - Select if you connect this unit's DIGITAL AUDIO OUT and HDMI OUT jack to a device with LPCM, Dolby Digital, Dolby Digital Plus, Dolby TrueHD, DTS and DTS-HD. Notes: • When [HDMI] option is set to [PCM Multi-CH], the audio may output as PCM Stereo if the PCM Multi-Ch information is not detected from HDMI device with EDID. • When [HDMI] and [SPDIF] options are set to [DTS Re-Encode], the DTS audio will output on BD and HD DVD advanced disc, and the original audio will output on the other discs (like [Primary Pass-True]). DRC (Dynamic Range Control) During the disc encoded in Dolby Digital or Dolby Digital Plus is playing back, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without losing clarity of sound. Set DRC to [On] for this effect. 21