LG KM710 Service Manual - Page 63
LCD Display Trouble shooting
![]() |
View all LG KM710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
4. Trouble Shooting 4.5 LCD Display Trouble shooting z LCD Control signals from Main Board - The signal of DBB is ELCD_DATA(16BIT), ELCD_CS/WR/ADS, ELCD_CS, - LCD MODULE POWER SOURCE and LCD reset. - The signal of TCC are composed of LCD_DATA(16BIT) and LCD_CS/WR/ADS ELCD_DATA(15:0) MM_INT FM_RESET LCD_CS MM_RESET ELCD_ADS ELCD_WR ELCD_RD BPEN GATED_IOEN SLCD_RST ELCD_DATA(0) ELCD_DATA(1) ELCD_DATA(2) ELCD_DATA(3) ELCD_DATA(4) ELCD_DATA(5) ELCD_DATA(6) ELCD_DATA(7) ELCD_DATA(8) ELCD_DATA(9) ELCD_DATA(10) ELCD_DATA(11) ELCD_DATA(12) ELCD_DATA(13) ELCD_DATA(14) ELCD_DATA(15) D21 F18 E19 G18 F20 H18 G19 H20 H19 H21 J20 J18 J21 J19 K21 N18 R18 V21 ELCD_DATA_0 ELCD_DATA_1 ELCD_DATA_2 ELCD_DATA_3 ELCD_DATA_4 ELCD_DATA_5 ELCD_DATA_6 ELCD_DATA_7 ELCD_DATA_8 ELCD_DATA_9 ELCD_DATA_10 ELCD_DATA_11 ELCD_DATA_12 ELCD_DATA_13 ELCD_DATA_14 ELCD_DATA_15 ELCD_DATA_16 ELCD_DATA_17 M14 M15 ELCD_NCS0 ELCD_NRESET L15 K15 ELCD_DNC ELCD_RNW D20 K14 ELCD_ESTRB ELCD_TE Y16 GPIO_10 V19 GPIO_18 GPIO 5 (INT) GPIO 63 GPIO 0 GPIO 7 z Check Point - The Assembly status of the LCD Module - The Soldering of connector - The FPCB which connects the LCD Module z Trouble Shooting Setup - Connect PIF Jig, and Power on LGE Internal Use Only - 64 - Copyright © 2008 LG Electronics. Inc. All right reserved. Only for training and service purposes
![](/manual_guide/products/lg-km710-service-manual-5eb4dc9/63.png)