LG LWS3081ST Owner's Manual (English) - Page 33

CARE & CLEANING Changing the Oven Light The oven light is a standard 10-watt halogen bulb for ovens. To replace lamps located on the side wall: • Make sure oven and bulb are cool. 1. Unplug oven or disconnect power. 2. Remove oven racks. 3. Slide a flat blade screwdriver between the housing and the glass light cover. 4. Support the glass light cover with two fingers to prevent the cover from falling to the bottom of the oven. 5. Gently twist the screwdriver blade to loosen the glass light cover. 6. Remove bulb from socket. 7. Replace bulb, replace light cover by snapping back into place. 8. Plug in oven or reconnect power. Glass Light Cover Housing Flat blade screwdriver To replace a lamp located on the top wall: • Make sure oven and bulb are cool. 1. Unplug oven or disconnect power. 2. Remove oven racks. 3. Slide a flat blade screwdriver between the housing and the glass light cover. 4. Support the glass light cover with two fingers to prevent the cover from falling to the bottom of the oven. 5. Gently twist the screwdriver blade to loosen the glass light cover. 6. Remove bulb from socket. 7. Replace bulb, replace light cover by snapping back into place and push the clip to hold the glass light cover tightly. 8. Plug in oven or reconnect power. Glass Light Cover Clip Housing Flat Blade screwdriver WARNING • Before replacing your oven light bulb, DISCONNECT the electrical power to the oven at the main fuse or circuit breaker panel. - Failure to do so can result in severe personal injury, death, or electrical shock. • Make sure oven and bulb are cool. Painted Parts and Trim For general cleaning, use a cloth with hot and soapy water. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials; they can scratch the parts and trim. Stainless Steel Surfaces Do not use a steel-wool pad, it will scratch the surface. 1. Place a small amount of Stainless Steel Appliance Cleaner or polish on a damp cloth or damp paper towel. 2. Clean a small area, rubbing with the grain of the stainless steel if applicable. 3. Dry and buff with a clean, dry paper towel or soft cloth. 4. Repeat as necessary. NOTE: If a mineral oil-based stainless steel appliance cleaner has been used before to clean the appliance, wash the surface with a mild soap and water prior to using the Stainless Steel Appliance Cleaner or polish. 33 ENGLISH