LG RU-44SZ63D Owners Manual - Page 4

(Continufreodmprevioupsage) 14. Outdoor Antenna Grounding If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded to provide protection against voltage surges and buiLt-up static charges. ArticLe 810 of the National ELectricaL Code (U.S.A.), ANSl/NFPA 70 provides information with regard to proper grounding of the mast and supporting structure, grounding of the Lead-in wire to an antenna discharge unit, size of grounding conductors, Location of antennadischarge unit, connection to grounding electrodes, and requirements for the grounding electrode. ExampLe of Grounding According to National ELectricaL Code Instructions Ground Clamp --\ _.F_i.g_.IL__ J NEC - National ELectricaL Code Antenna Lead in Wire Antenna Discharge Unit (NEC Section 810-20) Grounding Conductor (NEC Section 810-21) Ground Clamps ...----- Power Service Grounding Electrode System (NEC Art 250, Part H) 15, Lightning For added protection for this product (receiver) during a Lightning storm, or when it is Left unattended and unused for Long periods of time, unplug it from the waLLoutlet and disconnect the antenna or cable system. This wiLL prevent damage to the product due to Lightning and power-Line surges. 16. Power Lines An outside antenna system should not be Located in the vicinity of overhead power Lines or other electric Light or power circuits, or where it can faLLinto such power Lines or circuits. When instaLLing an outside antenna system, extreme care should be taken to keep from touching such power Lines or circuits as contact with them might be fataL. 17, OverLoading Do not overload waLLoutlets and extension cords as this can result in a risk of fire or electric shock. 18. Object and Liquid Entry Never push objects of any kind into this product through PAGE 4 openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spiLL Liquid of any kind on the product. 19. Servicing Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer aLLservicing to qualified service personneL. 20. Damage Requiring Service UnpLug this product from the waLL outlet and refer servicing to qualified service personnel under the foLLowing conditions: a. If the power-suppLy cord or plug is damaged. b. If Liquid has been spiLLed, or objects have faLLen into the product. c. If the product has been exposed to rain or water. d. If the product does not operate normaLLy by foLLowing the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and wiLL often require extensive work by a qualified technician to restore the product to its normal operation. e. If the product has been dropped or the cabinet has been damaged. f. If the product exhibits a distinct change in performance. 21. RepLacement Parts When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. 22, Safety Check Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 23. WaLL or CeiLing Mounting The productshould be mounted to a waLLor ceilingonly as recommended by the manufacturer. The product may slide or faLL, causing serious injury to a child or adult, and serious damage to the product. 24. Heat The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (incLuding amplifiers) that produce heat.