Lantronix EDS4100 EDS - User Guide - Page 63
Tunnel – Accept Mode, To con the Accept Mode of a specific tunnel, Tunnel, Accept Mode
View all Lantronix EDS4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
9: Line and Tunnel Settings Tunnel - Accept Mode Controls how a specific tunnel number behaves when a connection attempt originates from the network. In Accept Mode, the EDS waits for a connection from the network. The configurable local port is the port the remote device connects to for this connection. There is no remote port or address. The default local port is 10001 for serial port 1 and increases sequentially for each additional serial port, if supported. Accept Mode supports the following protocols: SSH (the EDS is the server in Accept Mode). When using this protocol, the SSH server host keys and at least one SSH authorized user must be configured. SSL TCP AES encryption over TCP Telnet (The EDS supports IAC codes. It drops the IAC codes when Telnetting and does not forward them to the serial port). Accept Mode has the following states: Disabled (never a connection) Enabled (always listening for a connection) Active if it receives any character from the serial port Active if it receives a specific (configurable) character from the serial port (same start character as Connect Mode's start character) Modem control signal Modem emulation To configure the Accept Mode of a specific tunnel: 1. Select Tunnel on the menu bar, if you are not already in the Tunnel web page. 2. Select a tunnel number at the top of the page. 3. Select Accept Mode. The Accept Mode page for the specific tunnel appears. EDS User Guide 63