Lenovo ThinkPad 390X English - Windows Me Setup Guide - Page 39
Cause, Resolution, Models, Issue
View all Lenovo ThinkPad 390X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Cause: Resolution: the first time, yellow "!" will appear on PCMCIA Card Services in the Device Manager as code 1. This does not cause any functionality loss. By Windows Me design Continue to use the PC Card. Once the system reboots, the yellow "!" disappears. 3.2 Adaptec SlimSCSI 1480A PC Card causes system hang Models: Issue: Resolution: ThinkPad models 390, 600X System hangs when Adaptec Slim SCSI 1480A in cold or hot inserted. SlimSCSI 1480A is not supported. 3.3 Wake-On-Ring (WOR) might not work when using some PC Card Modems Models: Issue: Cause: Resolution: All ThinkPad models When using some PC Card modems under Windows Me, you may notice a power management setting for the device listed in Device Manager. While Wake-On-Ring is enabled in the Power Manager, WOR feature may not function properly. OS does not support wakeup capability from Standby mode for an incoming call. This is a current limitation for this release of Windows Me. Only some CardBus modem cards support this function. Do not use the WOR function with PC Card modems. 3.4 Some PC cards might not be detected after resuming from Standby mode. Models: Issue: Cause: Resolution: ThinkPad 240X Some PC cards may not be detected when the system resumes from standby. This is caused by PC Card device driver. Install any PC cards prior to putting the system into Standby or Hot unplug and then plug PC Card. 3.5 IBM Token Ring PC Card driver is not included in Windows Me. Models: Issue: Resolution: All ThinkPad models IBM Token Ring PC Card driver is not included in Windows Me. Token Ring PC Card driver and the installation guide can be obtained at: http://www.networking.ibm.com. 3.6 ATA PC Card does not work. Models: Issue: Cause: Resolution: ThinkPad 600X ATA cards will have a resource conflict if "Warm swap device" for the IBM ThinkPad Ultra Bay is enabled Hardware Limitation Warm Swap for the IBM ThinkPad Device Bay must be disabled 1. Click Start → Settings → Control Panel 2. Double-click System icon 3. Double-Click ThinkPad Configuration