LevelOne FCS-5061 Manual - Page 32

IP Filter, Enable IP Filter, Add/ Delete IP Address

Get LevelOne FCS-5061 PDF manuals and user guides View all LevelOne FCS-5061 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

6.3.2.3 IP Filter The IP Filter setting can be found under this path: System> Security> IP Filter. Using the IP filter, access to the IP Camera can be restricted by denying/allowing specific IP addresses. Enable IP Filter Check the box to enable the IP Filter function. Once enabled, the listed IP addresses (IPv4) will be allowed/ denied access to the IP Camera. Select or from the drop-down list and click on the button to determine the IP Filter behavior. Add/ Delete IP Address Input the IP address and click on the button to add a new filtered address. The Filtered IP Addresses list box shows the currently configured IP addresses. Up to 256 IP address entries may be specified. To remove an IP address from the list, please select the IP and then click on the button. 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
32
6.3.2.3
IP Filter
The IP Filter setting can be found under this path: System> Security> IP Filter.
Using the IP filter, access to the IP Camera can be restricted by
denying/allowing specific IP addresses.
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP
addresses (IPv4) will be allowed/ denied access to the IP Camera. Select
<Allow> or <Deny> from the drop-down list and click on the <Apply> button to
determine the IP Filter behavior.
Add/ Delete IP Address
Input the IP address and click on the <Add> button to add a new filtered
address. The Filtered IP Addresses list box shows the currently configured IP
addresses. Up to 256 IP address entries may be specified.
To remove an IP address from the list, please select the IP and then
click on the <Delete> button.