Linksys DSHUB24 User Guide - Page 10
Baud Rate, Data Bits, Parity, Stop Bits, Flow Control - default password
UPC - 745883548699
View all Linksys DSHUB24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Run a terminal program on your PC - for example, run the HyperTerm program under Windows 95/98 - and set the following parameters Baud Rate: Data Bits: Parity: Stop Bits: Flow Control: 38400 8 None 1 No 4. Connect your PC to the SNMP module using one of the PC's active serial ports. Directly connect them using a DB-9 male to DB-9 male serial cable. Do not use a null modem cable. 5. Turn on the hub. 6. You will see diagnostic messages in the terminal window. The hub is running a self-test. Please wait for it to finish, and watch to make sure that the hub passes all of the tests. 7. After the hub finishes its self-test, you will notice that the LEDs on the hub(s) are displaying management information. On the hub that is managed, the MNGMNT light will be on. You will be prompted to enter a password. There are three access levels. Your access to the hub's management capabilities will be determined by the password that you give. MANAGER The manager has access to all functions on the hub and can configure any of the hub's settings. The default password for this level is "manager" 7