Linksys DSHUB24 User Guide - Page 11

Subnet addressing scheme of your network. You can also set - support

Get Linksys DSHUB24 - EtherFast StackPro II Hub PDF manuals and user guides
UPC - 745883548699
View all Linksys DSHUB24 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

OPERATOR The operator can set only the variables under the portconfiguration menu. All other variables are only read-only. The default password for this level is "operator" USER The user level offers read-only access to the hub's settings. The default password for the user level is "user" You should change all three of the SNMP module's passwords under the "Change Password" sub-menu later. 8. Enter the manager password. You will see a command menu. 9. The first thing you should do is change the hub unit's IP address. The default address for the hub is 192.168.0.1. Press 2 to get to the "Protocol Configuration" menu. Give the hub a unique IP address in this format: nnn.nnn.nnn.nnn The values for each variable in the address should fall between 0 and 255. Be sure that the IP address fits into the Subnet addressing scheme of your network. You can also set the Subnet Mask and the Routing Address from the "System Setting" menu. 10. After the IP address has been set, you can manage your hub by using a Network Management application (such as HP OpenView) or a web browser from anywhere on the network. Any browser you use must support frames, Java, and HTML 3.2 or higher. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
OPERATOR
The operator can set only the variables under the port-
configuration menu. All other variables are only read-only.
The default password for this level is "operator"
USER
The user level offers read-only access to the hub's settings.
The default password for the user level is "user"
You should change all three of the SNMP module's passwords
under the "Change Password" sub-menu later.
8. Enter the manager password. You will see a command
menu.
9. The first thing you should do is change the hub unit's IP
address. The default address for the hub is 192.168.0.1.
Press 2 to get to the "Protocol Configuration" menu. Give the
hub a unique IP address in this format: nnn.nnn.nnn.nnn
The values for each variable in the address should fall
between 0 and 255. Be sure that the IP address fits into the
Subnet addressing scheme of your network. You can also set
the Subnet Mask and the Routing Address from the "System
Setting" menu.
10. After the IP address has been set, you can manage your
hub by using a Network Management application (such as HP
OpenView) or a web browser from anywhere on the network.
Any browser you use must support frames, Java, and HTML
3.2 or higher.
8