Linksys DSHUB24 User Guide - Page 13

Using the Command Line Interface - setup

Get Linksys DSHUB24 - EtherFast StackPro II Hub PDF manuals and user guides
UPC - 745883548699
View all Linksys DSHUB24 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Using the Command Line Interface The command line interface can be accessed through the terminal port on the back of the SNMP module or through a telnet connection from any computer on the network. You must configure at least the IP address of the unit using the command line interface before accessing it through the web interface. Before entering the command line interface, the hub will run several diagnostic tests and it will prompt you to enter a password. Enter the manager's password. The default password for the manager access level is "manager". It will remain "manager" until you change it. The main menu for the command line interface looks like this Network Management Module Setup Main Menu [1] System Settings [2] Protocol Configuration [4] Restart Management Kit [5] SNMP Configuration [7] Port Management [8] Firmware Update [9] Modify Password [S] Save Current Settings [R] Restore Default Values [S] Save Current Settings [R] Restore Default Values [X] Exit 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
Using the Command Line
Interface
The command line interface can be accessed through the ter-
minal port on the back of the SNMP module or through a tel-
net connection from any computer on the network.
You
must
configure
at least
the IP address of the unit using
the command line interface before accessing it through the
web interface.
Before entering the command line interface, the hub will run
several diagnostic tests and it will prompt you to enter a pass-
word. Enter the manager's password. The default password for
the manager access level is "manager". It will remain "manag-
er" until you change it.
The main menu for the command line interface looks like this
Network Management Module Setup
Main Menu
--------------------------------------------
[1] System Settings
[2] Protocol Configuration
[4] Restart Management Kit
[5] SNMP Configuration
[7] Port Management
[8] Firmware Update
[9] Modify Password
[S] Save Current Settings
[R] Restore Default Values
[S] Save Current Settings
[R] Restore Default Values
[X] Exit
10