Mackie PPM1008 Owner's Manual - Page 7

Owner's Manual Microphones Acoustic Guitar and Mic Front Panel Power Amp Mode switch set to Mains/Mon 1 Rear Panel Adjust Vocal Compression press HI-Z button Drum Machine Power Amplifier dual-mono mode C300z Passive Stage Monitors (plays mon 1 output) Keyboards SRM150 Powered Monitor (plays mon 1 output) Passive Subwoofers (plays main mix below 100 Hz) C300z Passive Speakers House System (plays mono main mix) This diagram shows microphones attached to the mic inputs of channels 1 to 4, an electric guitar connected directly to channel 5 (with hi-z switch pressed in), an acoustic guitar mic connected to channel 6 mic in, a keyboard attached to channel 7's stereo inputs, and a drum machine to channel 8. A Mackie SRM150 powered monitor is connected to the monitor 1 send, and acts as a personal stage monitor to the keyboard player. The mon 1 knobs of each channel allow you to set up a monitor mix that is independent of the main mix. The power amp mode switch is set to play the mono main mix on ch. A, and monitor 1 mix on ch. B. C300z passive speakers are connected to the channel A speaker-level power output of the powered mixer, and they play the main mono mix to your audience. C300z passive stage monitors are connected to the channel B speaker-level power output of the powered mixer. These play the stage monitor mix 1 to your performers. Passive subwoofers are powered by an amplifier connected to the main mix sub out, to reinforce the low end in your main mix. House of Worship System Owner's Manual 7