Mackie PPM1008 Owner's Manual - Page 9

Owner's Manual Microphones Front Panel Power Amp Mode switch set to Mon 1/Mon 2 Rear Panel Adjust Vocal Compression press HI-Z buttons Send Guitar Processor Return (connected to INSERT) Keyboards Electronic Drum Kit HD1531 Powered Speaker HD1531 Powered Speaker C200 Passive Stage Monitors (plays mon 2 output) C300z Passive Stage Monitors (plays mon 1 output) HD1801 Powered Subwoofer (plays right main mix) HD1801 Powered Subwoofer (plays left main mix) This diagram shows microphones attached to the mic inputs of channels 1 to 4, electric guitars connected directly to ch. 5 and 6 (with hi-z switches pressed in), a guitar processor connected to ch.6 insert, a keyboard attached to channel 7's stereo inputs, and an electronic drum kit attached to channel 8. Add vocal compression as required, by tweaking the compression knobs on channels 1 to 4. The power amp mode switch is set to play the monitor 1 mix on channel A, and monitor 2 mix on channel B. Note: Press in the front panel FX send/mon 2 send switch, or monitor 2 will not play. C200 passive stage monitors are connected to the channel B speaker-level power output of the powered mixer. These play the stage monitor mix 2 to your performers. C300z passive stage monitors are connected to the channel A speaker-level power output, and play stage monitor mix 1. Mackie HD1531 powered speakers and HD1801 powered subwoofers are connected to the line-level main mix outputs, and play the stereo main mix to your audience. Large Band System Owner's Manual 9