Magellan MobileMapper CE Getting Started Guide - Page 41
Direct IP Configuration, Direct IP, Configuration, Real-Time Correction Age Limit, Connect, Please
UPC - 763357115567
View all Magellan MobileMapper CE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
English To create a second Direct IP configuration, you would tap the down arrow to the right of the Direct IP Configuration field and select New. The Add button would appear again under the field. You would then tap this button, enter the three parameters of the second configuration and tap OK to save this new configuration. - After selecting the desired configuration from the Direct IP Configuration field, set the Real-Time Correction Age Limit parameter according to your needs (see recommendations on page 63). - Tap OK. This takes you back to the DGPS Configuration window. On top of the screen, you can read part of the settings you have just made. - Tap the Connect button. The DGPS Configuration screen now indicates the amount of incoming data packets (bottom of the screen) as well as the status of the DGPS mode (top of the screen). - Tap OK to close the DGPS Configuration window. The following two messages are displayed successively: "Please wait..." and "Processing incoming data packets...". - Tap OK to close the message window. - Run GPS Status (see Viewing Current GPS Status on page 14) and check that MobileMapper CE is now operating in DGPS mode. - Start your application. 35