Makita EB7660TH EB7660TH EB7660WH Instruction Manual - Page 13

3. Loosen the oil drain bolt to let the oil drain out. Be careful not to allow oil to get on the fuel tank or other parts. NOTICE: Be careful not to lose the gasket (aluminum washer). Put the oil drain bolt in a location where it does not get dirt. 4. Remove the oil cap. (Removing the oil cap allows the oil to drain easily.) NOTICE: Be sure to set the oil cap down in a location where it does not get dirt. 5. As the level of the oil being drained decreases, tilt the blower over on to the side with the drain so that the oil will completely drain out. 6. After the oil has completely drained out, tighten the oil drain bolt securely. If the bolt is not tightly fastened, it may result in oil leakage. NOTICE: Do not forget to put the gasket (aluminum washer) back on when reattaching the drain plug. 7. Pour approximately 220 ml (7.4 fl oz) oil into the oil refill port up to the upper limit of the oil gauge. 1 2 3 4 ► 1 . Oil gauge 2. Upper limit mark 3. 100 ml (3.4 fl oz)level 4. Lower limit mark 8. After filling with oil, tighten the oil cap securely to prevent oil leaks. NOTICE: Do not forget to put the oil cap gasket back on when reattaching the oil cap. Cleaning of air cleaner WARNING: INFLAMMABLES STRICTLY PROHIBITED Interval of Cleaning and Inspection Daily (every 10 operating hours) Cleaning procedure 4 3 2 3. Remove the element and clean off any dirt from the element with a cloth or air blow. Replace the element with a new one if it is damaged or very dirty. NOTE: The element is a dry type and should not get wet. Never wash with water. 4. Wipe off any oil around the breather with a rag or cloth. 5. Install the element in the air cleaner case. 6. Attach the air cleaner cover and tighten the knob bolts. NOTICE: Clean the element several times a day, if excessive dust adheres to it due to dusty environment. NOTICE: If operation continues with the element remaining not cleared of oil, oil in the air cleaner may fall outside, resulting in oil contamination. Checking the spark plug CAUTION: Do not touch the spark plug while the engine is running. Otherwise electrical shock may result. CAUTION: Set the stop control lever/stop switch to OFF "O" position. CAUTION: Check the spark plug cord regularly. If it is damaged or torn, replace it. Otherwise electrical shock may result. NOTICE: When removing the spark plug, clean the spark plug and cylinder head first, so that no dirt, sand, etc will enter the cylinder. NOTICE: Remove the spark plug after the engine has cooled down in order to avoid damaging the threaded hole in the cylinder. NOTICE: Install the spark plug properly into the threaded hole. If installed at an angle, the threaded hole in the cylinder will get damaged. 1. To open the plug cover, lift it and make a half turn of it. 1 ► 1 . Plug cover 2. Use the box wrench provided as an standard accessory to remove and install the spark plug. 1 ► 1 . Knob bolts 2. Air cleaner cover 3. Element 4. Breather 1. Loosen the knob bolts. 2. Remove the air cleaner cover. 13 ENGLISH