Marantz PM-11S1 PM-11S1 User Manual - Page 12
Names And Functions Of Parts
View all Marantz PM-11S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
NAMES AND FUNCTIONS OF PARTS FRONT PANEL ENGLISH INPUT SELECTOR DISPLAY TONE SPEAKER A SPEAKER B INTEGRARED AMPLIFIER PM-11S1 PHONES OPERATE POWER ON/OFF ATT. PRE OUT REC OUT PHONO MC VOLUME q POWER ON/OFF Switch This switch turns power to the PM-11S1 ON and OFF. When pressed, power is activated and the blue indicator on the display w lights up. Approximately 8 seconds after power is activated, audio output is enabled. Pressing the switch again turns power OFF. w Display The display displays the selected input source, volume level and setting status. e INPUT SELECTOR Knob This knob is for selecting the input source to use in playback and recording. The selected input source is displayed on the display w. r VOLUME Knob This knob is for setting the volume. The volume level is displayed on the display w. Turning the knob clockwise increases the volume, while turning it counterclockwise decreases the volume. When turned slowly, the volume can be fine-adjusted in 0.5 dB steps, whereas when turned rapidly, volume level changes greatly. t Infrared Receptor Window This is the receptor of control signals sent from the included RC-11PMS1 remote controller. Point the remote controller towards this window to properly send signals. y PHONES Jack This jack is for connecting headphones with a standard stereo plug. To listen with headphones, turn speaker output OFF by setting the SPEAKER A and B buttons in the OFF position. u DISPLAY Button This button turns the display and side illumination ON and OFF. The button performs two functions depending on how long it is pressed. If pressed and held for 3 seconds or longer: 8 Turns the side illumination !4 on both sides of the display ON and OFF. This operation sets the always-ON mode of the side illumination, therefore once the side illumination is turned OFF, it stays OFF and does not light even if power is shut OFF and reactivated. To turn the side illumination ON again, press and hold the DISPLAY button for 3 seconds or longer. If pressed and held for less than 3 seconds: Turns the display ON and OFF. When the always-ON mode is engaged for the side illumination, the side illumination turns ON and OFF in synch with the display. If the display is out and the VOLUME knob or other control is operated, the display lights up. It will automatically go out 3 seconds after the operation has been completed. For instructions on how to operate the side illumination, see "HOW TO OPERATE THE SIDE ILLUMINATION" on pg. 16. i TONE Button This button turns the bass and treble tone control ON and OFF. When tone control is ON, the center of the button is lit a blue color. For instructions on how to adjust bass and treble, see "How to Trim Bass" and "How to Trim Treble" on pg. 18. o SPEAKER A/B Buttons These buttons turn the speaker output to the speakers connected to the SPEAKER SYSTEM A/B terminals on the rear panel ON and OFF. When speaker output is ON, the center of the button is lit a blue color. To listen with headphones, turn speaker output OFF. !0 ATT Button This button attenuates volume with one press of the button. When pressed, "ATT" flashes on the display and the volume is reduced. If pressed again, the mode is canceled and the original volume level is restored. Attenuation level is set to -20 dB when the PM-11S1 is shipped from the factory, but it can be set to either -40 dB or -∞ (mute). For instructions on how to set attenuation level, see "How to Set Attenuation Level" on pg. 16.