Marantz PM-11S1 PM-11S1 User Manual - Page 18

ENGLISH BASIC OPERATION RECORDING This example explains how to record from an input source such as an Super Audio CD player to a recording device such as a CD-R. 1. Press the power ON/OFF switch of the Super Audio CD player and CD-R to activate power to both components. 2. Press the POWER ON/OFF switch q of the PM-11S1 to activate power to it. Approximately 8 seconds after power has been activated, the muting turns OFF and audio output is enabled. When using multiple PM-11S1s connected by FCBS, turn power ON in the order of lowest to highest ID number, starting from ID 1. 3. Select the input source from the INPUT SELECTOR knob e on the PM-11S1 or the input selector buttons z of the remote controller. And, press the REC OUT button !2 to turn the recording output of RECORDER 1 and 2 ON. 4. Load a playback disc into the Super Audio CD player and a recording disc into the CD-R. 5. Start playback on the Super Audio CD player. Then, start recording on the CD-R. 6. To use the speakers connected to the SPEAKER A terminals, press the SPEAKER A button o on the PM11S1. 7. Adjust the volume level from the VOLUME knob r on the PM-11S1 or the VOLUME 3/4 buttons n of the remote controller. Note When RECORDER 1 is selected as the input source, signals are not output to the RECORDER 1 OUT jack. The same goes for the RECORDER 2 OUT jack when RECORDER 2 is selected as the input source. INPUT SELECTOR DISPLAY TONE SPEAKER A SPEAKER B INTEGRARED AMPLIFIER PM-11S1 PHONES OPERATE POWER ON/OFF ATT. PRE OUT REC OUT PHONO MC VOLUME OPEN/ CLOSE SOUND MODE PHONO BALANCED CD RECORDER 1 LINE 1 RECORDER 2 TRIM EXIT LINE 2 TONE + L R ENTER DISPLAY - ATT VOLUME RANDOM SCAN REPEAT TOP MENU RETURN AM/A FM/B MENU RC-11PMS1 14