Maytag MGR5751BDQ Installation Manual - Page 9
Conversion - range
View all Maytag MGR5751BDQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GAS CONVERSION To access the regulator from front of range, remove the storage drawer or warming drawer. To remove storage drawer: Pull out to the first stop position. Lift up front of drawer and pull to the second position, grasp sides and lift up and out to remove drawer. To replace: Fit the drawer rollers onto the rails. Lift up drawer front and gently push in to first stop position. Lift up and continue to slide drawer to the closed position. TO REMOVE WARMING DRAWER: 1. Empty drawer and pull out to its full open position. 2. Locate the black triangle levers on each side of the drawer. TO REPLACE WARMING DRAWER: a. Pull the bearing glides to the front of the chassis glide. (See picture below). BEARING GLIDE LEVER b. Align the glide on each side of the drawer with the glide slots on the range. (See picture below). 3. Press the lever DOWN on the RIGHT side and lift the lever UP on the LEFT side at the same time. Then pull drawer out another inch. 4. Carefully pull the drawer all the way out holding on to the sides, not the drawer front. c. Push the drawer into the range until levers "click" (approximately 2²). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps a through c. This will minimize possible damage to the bearing glides. See Gas Conversion Instructions located on the back of the range in the Assembly Kit. -9-