Motorola Moto 360 2nd Gen. Moto 360 2nd Gen User Guide - Page 19

Watch bands (Moto 360 fashion watches only) Watch bands (Moto 360 fashion watches only) Remove/replace your watch band Watch band warning Care for the leather watch band Resize your metal watch band Menu Back More Next Remove/replace your watch band Quick-release bands for your Moto 360 (2nd Gen.) fashion watch are designed to be swapped easily. To remove the watch band: Place your Moto 360 face down on a soft cloth. Slide the metal latch on one band toward the center of the band to release its pin from the watch. Then gently angle the band away from the watch to remove it. Repeat with the other band. Slide the latch toward the center of the band. To attach the watch band: Take one band and insert the pin on the side opposite the latch into the hole in the watch. Slide the latch toward the center of the band and insert its pin into the other hole. Tug gently to ensure the band is secure. Repeat with the other band. Tip: For leather watch bands, make sure the band with the buckle is on the top side of the watch. Watch band warning Your Moto 360 watch uses custom designed watch bands. Using standard off-the-shelf watch bands, especially metal bands, may cause significant damage to your watch. Damage caused by using a non-Motorola watch band, or by its improper replacement, is not covered by the warranty. Care for the leather watch band If your watch has a leather watch band, please note that the leather watch band has been hand treated with several stain coats to give a rich finish. Some wear and transfer of color may be possible. As with many leathers, please use discretion when wearing lighter colored garments. To clean, wipe with a soft, damp cloth. Do not use any polishes or creams. Like most leather products, the watch band must be treated with care. Direct exposure to water is not recommended. Resize your metal watch band Do you need to resize your metal band? We recommend taking your Moto 360 to a jeweler or watch repair shop for assistance.