NEC C551 User Manual - English - Page 30
English-28, for PICTURE MODE.
View all NEC C551 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
COLOR SYSTEM VIDEO input only The selected Color System depends on the video format of the input signal. AUTO NTSC Automatically chooses Color System setting based on input signal. PAL SECAM 4.43 NTSC PAL-60 INPUT RESOLUTION VGA (RGB) input only Selects one of the following pair of resolutions as the input signal priority: 1366 x 768 or 1280 x 768 or 1024 x 768 (vertical resolution 768) ASPECT*1 Select the aspect ratio of the screen image. NOTE: When the ASPECT is ZOOM, the image will be changed to FULL image before TILE MATRIX, and then start TILE MATRIX. After TILE MATRIX, the ASPECT will be returned to the previous ASPECT or set ASPECT during TILE MATRIX. If you change H POSITION and V POSITION settings with a reduced image, the image would not be changed. If SCREEN SAVER is set, the ASPECT setting automatically changes to FULL from what you set. Once SCREEN SAVER is off the ASPECT setting will go back to the setting that you originally set. This function is not available when MOTION in SCREEN SAVER is active. When the ASPECT is set to ZOOM while TILE MATRIX is set to active, after releasing TILE MATRIX or ZOOM will be active. POINT ZOOM function has limitations, please refer to POINT ZOOM (See page 49). NORMAL Shows the aspect ratio as it is sent from the source. FULL Fills the entire screen. WIDE Expands a 16:9 letterbox signal to fill the entire screen. 1:1 Shows the image in a 1 by 1 Pixel format. ZOOM Expands/reduces the image. NOTE: The areas of the expanded image that are outside of the active screen area are not shown. The reduced image may have some image degradation. ZOOM Maintains the aspect ratio while zooming. HZOOM Horizontal zoom value. VZOOM Vertical zoom value. H POS Horizontal position. V POS Vertical position. ADVANCED OVER SCAN*2 HDMI1, HDMI2, HDMI3, DisplayPort, VGA (YPbPr), VIDEO inputs only Some video formats may require different scanning modes in order to best display the image. AUTO Image size is set automatically. NOTE: This function is not available if input signal is VGA (YPbPr), VIDEO or MP. ON Image size is larger than what can be displayed. The image edge will appear cropped. Approximately 95% of the image will be shown on the screen. OFF Image size stays within the display area. The whole image is displayed on the screen. NOTE: When you use a computer with HDMI out, please set "OFF". NOISE REDUCTION VIDEO input only Adjusts the amount of noise reduction. Press + or - to adjust. TELECINE*2 HDMI1, HDMI2, HDMI3, DisplayPort, VIDEO, VGA (YPbPr) inputs only Automatically senses the sources frame rate for optimal picture quality. ADAPTIVE CONTRAST*2, *3 HDMI1, HDMI2, HDMI3, DisplayPort, VIDEO, VGA (YPbPr), MP inputs only Sets the level of adjustment for dynamic contrast. If HIGH is set, the image is displayed clearly but it makes brightness unstable due to the wide gap of contrast variation. RESET Resets all "PICTURE" settings back to factory settings except for PICTURE MODE. *1: Except for MP. *2: This function is not available in HDMI/DisplayPort MODE when RGB is selected or when AUTO is selected and the input signal is RGB. *3: This function is not available for still image by MP input. English-28