NEC C551 User Manual - English - Page 9
Attaching Mounting Accessories, Installing and removing the optional, table top stand - manual
View all NEC C551 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
300 mm English Attaching Mounting Accessories The monitor is designed for use with the VESA mounting system. 1. Attach Mounting Accessories Be careful to avoid tipping the monitor when attaching accessories. VESA Mounting Interface (M6) Height adjustment 1. The lines on the stand pole are indicators of the height adjustment. Please adjust the pipe to the lines. Pipe C551 High/Low C501 C431 Adjust the pipe to a line. Stand pole 2. Please install the stand pole and the pipe with included screws. Please screw the two screw holes at the pipe. 300 mm Mounting accessories can be attached with the monitor in the face down position. To avoid damaging the front face, place the protective sheet on the table underneath the LCD monitor. The protective sheet was wrapped around the LCD monitor in the original packaging. Make sure there is nothing on the table that can damage the monitor. When using mounting accessories other than NEC compliant and approved, they must comply with the VESA Flat Display Mounting Interface Standard (FDMI). NOTE: Prior to installation, be sure to place the monitor on a flat area with adequate space. 2. Installing and removing the optional table top stand CAUTION: Installing and removing the stand must be done by two or more people. For installation, follow the instructions included with the stand or mounting equipment. Use only those devices recommended by the manufacturer. NOTE: ONLY use screws which are supplied with the optional table top stand. When installing, do not put your hands on the monitor or apply force. The monitor may become distorted. When installing the LCD monitor stand, handle the unit with care to avoid pinching your fingers. NOTE: Use the ST-401. Please refer to the ST-401 user's manual for more detail. Pipe Stand pole NOTE: Installing the monitor at the wrong height can cause tipping. Please install your monitor at proper height. 3. Ventilation Requirements When mounting in an enclosed space or recessed area, leave adequate room between the monitor and the enclosure to allow heat to disperse, as shown below. 100 mm 30 mm 100 mm 100 mm 100 mm Must be under 40 Degree Celsius. Allow adequate ventilation or provide air conditioning around the monitor, so that heat can properly dissipate away from the unit and the mounting equipment; especially when you use monitors in a multiple screen configuration. NOTE: The sound quality of the internal speakers will be different depending on the acoustics of the room. English-7