NEC LT280 LT280/LT38 UM - Page 17
Ter minal Panel Features, COMPUTER 3 IN Connector DVI-D 24 Pin HDCP
UPC - 050927250569
View all NEC LT280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Terminal Panel Features 1. Introduction 15 7 14 13 12 4 1 USB PC CARD COMPONENT IN LAN AUDIO IN COMPUTER 3 IN COMPUTER 1 IN Y Cb/Pb Cr/Pr S-VIDEO IN VIDEO IN AUDIO IN L/MONO R AUDIO OUT MONITOR OUT 3 (LT380 only) COMPUTER 2 IN 2 PC CONTROL 8 9 10 6 5 11 The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not affect the projector's performance. 1. COMPUTER 1 IN/Component Connector (Mini DSub 15 Pin) (→ page 13, 15, 16) 2. COMPUTER 2 IN/Component Connector (Mini DSub 15 Pin) (→ page 13, 16) 3. COMPUTER 3 IN Connector (DVI-D 24 Pin) (HDCP compatible) (→ page 14) (Not available on LT280) 4. AUDIO IN (Stereo Mini Jack) (→ page 13, 14, 16) 5. MONITOR OUT Connector (Mini D-Sub 15 Pin) (→ page 16) 6. AUDIO OUT (Stereo Mini Jack) (→ page 16) 7. COMPONENT IN (Y, Cb/Pb, Cr/Pr) Connectors (RCA) (→ page 17) 8. S-VIDEO IN Connector (Mini DIN 4 Pin) (→ page 18) 9. VIDEO IN Connector (RCA) (→ page 18) 10. AUDIO L/MONO, R (RCA) (→ page 17, 18) 11. PC CONTROL Port (Mini D-Sub 9 Pin) (→ page 116, 117) Use this port to connect your PC or control system to control your projector via a serial cable. This enables you to control the projector using serial communication protocol. A commercially available RS232C cross cable is required to use this port.You can also control the projector by using PC Control Utility 3.0 contained on the supplied User Supportware 3 CD-ROM. To do so you must first have PC Control Utility 3.0 installed on your PC. If you are writing your own program, typical PC control codes are on page 116. 12. LAN Port (RJ-45) (→ page 19, 48) 13. USB Port (Type A) (→ page 35, 47) 14. PC CARD Eject Button (→ page 22) 15. PC CARD Slot (→ page 21) 7