NEC LT280 LT280/LT38 UM - Page 40
Repeat steps 2 and 4 to correct keystone distortion., After completing Keystone correction
UPC - 050927250569
View all NEC LT280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
5. Repeat steps 2 and 4 to correct keystone distortion. 3. Projecting an Image (Basic Operation) 6. After completing Keystone correction, press the ENTER button. The Keystone screen will disappear. • To perform Keystone correction again, press the 3D REFORM button to display the Keystone screen and repeat above steps 1 to 6. NOTE: • Turning on the projector will reset the previous correction setting values and correct distortion anew if the projection angle is changed from the last use. If the projection angle is the same as in the last use, the previous correction setting values are retained in the memory. To use the previous correction setting values after changing projection angle, select [Manual] in [Keystone] from the menu. (→ page 77) • To reset the 3D Reform correction setting values, press and hold the 3D REFORM button for a minimum of 2 seconds. • Each time the 3D REFORM button is pressed, the item will change as follows: Keystone → Cornerstone → None → Keystone → ... For information on [Cornerstone], see "Correcting Horizontal and Vertical Keystone Distortion (Cornerstone) on page 38. • The 3D Reform feature can cause an image to be slightly blurred because the correction is made electronically. 30