NEC UN552S External Controls - Page 100
Auto ID Complete
View all NEC UN552S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
19.2 Auto ID Complete This command is used in order to notify complete status of Auto ID. 1) The monitor sends the controller to complete status of Auto ID. Header SOH-'0'-Monitor ID- '0'-'A'-'0'-'C' Message STX-'C'-'A'-'0'-'A'-'0'-'2'-ST-MON-ETX Check code BCC Header SOH (01h): Start of Header '0' (30h): Reserved Monitor ID: Specify the Monitor ID of which you want to change a setting. Ex.) If Monitor ID is '1', specify 'A'. '0' (30h): Message sender is the controller. 'A' (41h): Message type is "Command". '0'-'C'(30h,43h): Message length (12byte) Delimiter CR Message STX (02h): Start of Message 'C'-'A'-'0'-'A'-'0'-'2' (43h, 41h, 30h, 41h, 30h, 32h): Auto ID '0'-'2' (30h,32h): Complete ST: Error Status No Error : 00h (30h, 30h) Error : 01h (30h, 31h) MON: DETECTED MONITORS 01h (30h, 31h) - 64h (36h, 34h) ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.3 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet 2) The controller replies to the monitor. Header SOH-'0'-'0'-Monitor ID- 'B'-'0'-'A' Message Check code STX-'C'-'B'-'0'-'A'-'0'-'2'-ST-ETX BCC eader SOH (01h): Start of Header '0' (30h): Reserved '0' (30h): Message receiver is the controller. Monitor ID: Indicate a replying Monitor ID. Ex.) When this byte is set to 'A', replying monitor's ID is '1'. 'B' (42h): Message type is "Command reply". '0'-'A'(30h,41h): Message length (10byte) Delimiter CR Message STX (02h): Start of Message 'C'-'B'-'0'-'A' (43h, 42h, 30h, 41h): Auto ID Reply Command '0'-'2' (30h,32h): Complete ST : Error Status No Error : 00h (30h, 30h) *Fixed ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.3 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet (100/145)