NEC UN552S External Controls - Page 109
Auto Tile Matrix Complete
View all NEC UN552S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
21.2 Auto Tile Matrix Complete This command is used in order to notify complete status of Auto Tile Matrix Setup. 1) The monitor notifies that Auto Tile Matrix completed to controller. Header SOH-'0'-Monitor ID- '0'-'A'-'0'-'A' Message STX-'C'-'A'-'0'-'3'-'0'-'2'-ST-ETX Check code BCC Header SOH (01h): Start of Header '0' (30h): Reserved Monitor ID: Specify the Monitor ID of which you want to change a setting. Ex.) If Monitor ID is '1', specify 'A'. '0' (30h): Message sender is the controller. 'A' (41h): Message type is "Command". '0'-'A'(30h, 41h): Message length (10bytes) Delimiter CR Message STX (02h): Start of Message 'C'-'A'-'0'-'3'-'0'-'2' (43h, 41h, 30h, 33h, 30h, 32h): Auto Tile Matrix Complete '0'-'2' (30h, 32h): Notify ST: Error Status No Error : 00h (30h, 30h) Error : 01h (30h, 31h) ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.3 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet 2) The controller replies to the monitor. Header SOH-'0'-'0'-Monitor ID- 'B'-'0'-'A' Message Check code STX-'C'-'B'-'0'-'3'-'0'-'2'-ST-ETX BCC Header SOH (01h): Start of Header '0' (30h): Reserved '0' (30h): Message receiver is the controller. Monitor ID: Indicate a replying Monitor ID. Ex.) When this byte is set to 'A', replying monitor's ID is '1'. 'B' (42h): Message type is "Command reply". '0'-'A'(30h, 41h): Message length (10bytes) Delimiter CR Message STX (02h): Start of Message 'C'-'B'-'0'-'3' (43h, 42h, 30h, 33h): Auto Tile Matrix Command '0'-'2' (30h, 32h): Notify ST: Error Status No Error : 00h (30h, 30h) *Fixed ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.3 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet (109/145)