NEC X981UHD External Control Codes - Page 21
Get Timing Report and Timing reply. - display
View all NEC X981UHD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
5.5.2 Get Timing Report and Timing reply. The controller requests the monitor to report the displayed image timing. STX Command code '0' '7' ETX Ø Send "07"(30h, 37h) as Get Timing Report command. Ø Complete "Get Timing Report" command packet as follows; ASCII: 01h-30h-41h-30h-41h-30h-34h-02h-30h-37h-03h-CHK-0Dh SOH-'0'-'A'-'0'-'A'-'0'-'4'-STX-'0'-'7'-ETX-CHK- CR The monitor replies status as the following format; STX Command SS H Freq. V Freq. ETX '4' 'E' Hi Lo MSB LSB MSB LSB Ø SS: Timing status byte Bit 7 = 1: Sync Frequency is out of range. Bit 6 = 1: Unstable count Bit 5-2 Reserved (Don't care) Bit 1 1:Positive Horizontal sync polarity. 0:Negative Horizontal sync polarity. Bit 0 1:Positive Vertical sync polarity. 0:Negative Vertical sync polarity. Ø H Freq: Horizontal Frequency in unit 0.01kHz Ø V Freq: Vertical Frequency in unit 0.01Hz Ex.) When H Freq is '1''2''A''9' (31h, 32h, 41h, 39h), it means 47.77kHz. (21/130)