Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P Setup Manual - Page 26

Netgear GSM7212P Manual

Get Netgear GSM7212P PDF manuals and user guides View all Netgear GSM7212P manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

7000 Series Managed Switch DHCP Server Configuration The following information is configured on the DHCP or BOOTP server The IP address (yiaddr) and subnet mask (option1) The name of the configuration file (bootfile or option 67) The IP address of the TFTP server (option 150) TFTP Server Configuration The configuration file is on the TFTP server (for example, switch.cfg). CLI: Switch Configuration 1. Have the configuration file saved after download from the TFTP server. (Netgear Switch) #boot autoinstall auto-save (Netgear Switch) #boot autoinstall start Autoinstall starts and waits for the boot options from the DHCP server. (Netgear Switch) #network protocol dhcp Changing protocol mode will reset ip configuration. Are you sure you want to continue? (y/n)y 2. Request an IP address, configuration file name, and TFTP IP address from the DHCP server. (Netgear Switch) # Config file 'startup-config' created successfully. AutoInstalled configuration is saved. (GSM7224P) #show autoinstall AutoInstall Mode...Stopped AutoInstall Persistent Mode...Enabled AutoSave Mode...Disabled AutoInstall Retry Count...3 AutoInstall State...AutoInstall is completed. Autoinstall is now completed. Auto Install Configuration 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Auto Install Configuration
26
7000 Series Managed Switch
DHCP Server Configuration
The following information is configured on the DHCP or BOOTP server:
°
The IP address (yiaddr) and subnet mask (option1)
°
The name of the configuration file (bootfile or option 67)
°
The IP address of the TFTP server (option 150)
TFTP Server Configuration
The configuration file is on the TFTP server (for example, switch.cfg).
CLI: Switch Configuration
1.
Have the configuration file saved after download from the TFTP server.
(Netgear Switch) #boot autoinstall auto-save
(Netgear Switch) #boot autoinstall start
Autoinstall starts and waits for the boot options from the DHCP server.
(Netgear Switch) #network protocol dhcp
Changing protocol mode will reset ip configuration.
Are you sure you want to continue? (y/n)y
2.
Request an IP address, configuration file name, and TFTP IP address from the DHCP
server.
(Netgear Switch) #
Config file 'startup-config' created successfully.
AutoInstalled configuration is saved.
(GSM7224P) #show autoinstall
AutoInstall Mode
..............................
Stopped
AutoInstall Persistent Mode
...................
Enabled
AutoSave Mode
.................................
Disabled
AutoInstall Retry Count
.......................
3
AutoInstall State
.............................
AutoInstall is
completed.
Autoinstall is now completed.