Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P Setup Manual - Page 5
Netgear GSM7212P Manual
View all Netgear GSM7212P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1. Getting Started 1 This manual includes software configuration tasks that are most commonly used when new switches are installed. To configure the switch software, connect a terminal to the switch. Note: Some products have Release Notes that detail the platform specific functionality of the switching, routing, SNMP, config, management, and other features. It is a good idea to read the Release Notes before setting up the switch. A number of other publications are available for your switch, including the following The NETGEAR Quick Installation Guide for your switch The Hardware Installation Guide for your switch NETGEAR ProSafe 7000 Managed Switch Software Administration Manual ProSafe Managed Switch Command Line Interface (CLI ) User Manual. Refer to this document for information about the command structure. This manual provides information about the CLI commands used to configure the switch and the stack. It provides CLI descriptions, syntax, and default values. These documents can be found at http://www.NETGEAR.com. In-Band and Out-of-Band Connectivity Ask the system administrator to determine whether you will configure the switch for in-band or out-of-band connectivity. Configuring the Switch for In-Band Connectivity In-band connectivity allows you to access the switch from a remote workstation using the Ethernet network. To use in-band connectivity, you must configure the switch with IP information (IP address, subnet mask, and default gateway). 5