Nikon D200 D200 User's Manual - Page 180

Custom Setting f4: Assign FUNC. Button This option controls the function performed by the FUNC. button. Option Description FV Lock If built-in flash or optional CLS-compatible Speedlight is used, flash value (default) locks when FUNC. button is pressed. Press again to cancel FV lock. FV Lock/ Lens Data As above, except that if built-in flash is lowered or optional CLS-compatible Speedlight is not attached, FUNC. button and command dials can be used to specify focal length and aperture of non-CPU lenses ( 93). 1 Step Spd/ Aperture If FUNC. button is pressed when rotating command dials, changes to shutter speed (exposure modes S and M) and aperture (exposure modes A and M) are made in increments of 1 EV. Same as AE-L/AF-L FUNC. button performs same functions as AE-L/AF-L button. Flash Off Flash will not fire in photos taken while FUNC. button is pressed. While FUNC. button is pressed, all shots in exposure or flash bracketing program will be taken each time shutter-release button is pressed. In con- Bracketing Burst tinuous high-speed and continuous low-speed modes, camera will repeat bracketing burst while shutter-release button is held down. If white-balance bracketing is selected, camera will take photos at up to 5 fps (single or continuous high-speed mode) or 1-4 fps (continuous low-speed mode) and perform white balance bracketing on each frame. Matrix Metering Matrix metering activated while FUNC. button is pressed. CenterWeighted Center-weighted metering activated while FUNC. button is pressed. Spot Metering Spot metering activated while FUNC. button is pressed. Focus Area Press FUNC. button and rotate command dials to cycle between normal Frame and wide focus areas ( 56). Custom Setting f5: Customize Command Dials This option controls the operation of the main and subcommand dials. Setup Custom Settings 170