Onkyo SC886 Instruction Manual - Page 117

Zone 2 and Zone 3-Continued Zone 2/Zone 3 Out Settings If you've connected your Zone 2 or Zone 3 speakers to an amp with no volume control, set the "Zone2 Out" or "Zone3 Out" setting, respectively, to "Variable" so that you can set the zone's volume, balance, and tone on the AV controller. 1 Press the [RECEIVER] REMOTE MODE button, followed by the [SETUP] button. The main menu appears onscreen. If the main menu doesn't appear, make sure the appropriate external input is selected on your TV. 2 Use the Up and Down [R]/[X] but- tons to select "7. Hardware Setup", and then press [ENTER]. The "Hardware Setup" menu appears. 5 Press the [SETUP] button. Setup closes. Note: This procedure can also be performed on the AV controller by using its [SETUP] button, arrow buttons, and [ENTER] button. Using Zone 2 and Zone 3 This section explains how to use Zone 2 and Zone 3. ZONE 3 ZONE 2 TONE OFF , 3 Use the Up and Down [R]/[X] but- tons to select "2. Zone2/Zone3", STANDBY and then press [ENTER]. ON The "Zone2/Zone3" screen appears. 7-2. Zone2/Zone3 Zone2 Out Zone3 Out Fixed Fixed INPUT SELECTOR MOVE VALUE RETURN RETURN SETUP EXIT 4 Use the Up and Down [R]/[X] but- tons to select "Zone2 Out" or "Zone3 Out", and use the Left and Right [F]/[S] buttons to select: Fixed: The Zone 2 or Zone 3 volume must be set on the amp in that zone. Variable: The Zone 2 or Zone 3 volume can be set on the AV controller. ZONE3 ZONE2 MUTING LEVEL-, LEVEL+ 117