Onkyo SC886 Instruction Manual - Page 55

First Time Setup-Continued Speaker Settings If you change these settings, you must run the automatic speaker setup again (see page 58). 1 2, 3 2-4 1, 5 To use bi-amping, you must change the "Speaker Type" setting. For hookup information, see page 25. Notes: • When bi-amping is used, the AV controller is able to drive up to 5.1 speakers in the main room. • Before you change these settings, turn down the vol- ume. The onscreen menus shown in this manual may be slightly different from what you see on your TV. 1 Press the [RECEIVER] button, followed by the [SETUP] button. The main menu appears onscreen. If the main menu doesn't appear, make sure the appropriate external input is selected on your TV. 3 Use the Up and Down [R]/[X] but- tons to select "1. Speaker Set- tings", and then press [ENTER]. The "Speaker Settings" menu appears. 2-1. Speaker Settings Speaker Type Normal MOVE VALUE RETURN RETURN SETUP EXIT 4 Use the Up and Down [R]/[X] but- tons to select "Speaker Type", and use the Left and Right [F]/[S] buttons to select: Normal: Select this if you've connected your front speakers normally. Bi-Amp: Select this if you've connected your front speakers for bi-amped operation. 5 Press the [SETUP] button. Setup closes. Note: This procedure can also be performed on the AV controller by using its [SETUP] button, arrow buttons, and [ENTER] button. 2 Use the Up and Down [R]/[X] but- tons to select "2. Speaker Setup", and then press [ENTER]. The "Speaker Setup" menu appears. 2. Speaker Setup 1. Speaker Settings 2. Speaker Config 3. Speaker Distance 4. Level Calibration 5. Equalizer Settings 6. THX Audio Setup 55