Onkyo TX-NR808 Owner Manual - Page 50
Source Setup, Audyssey DSX™, Theater-Dimensional, LFE Level, Audyssey - sound problems
View all Onkyo TX-NR808 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Note • If the "Surr Back" setting is set to "None" (➔ 46), this setting cannot be selected. • If the "Front High" or "Front Wide" setting is enabled (➔ 46), this setting is fixed at "Manual". DTS ■ Neo:6 Music Center Image ` 0 to 2 to 5 The DTS Neo:6 Music listening mode creates 6-channel surround sound from 2-channel stereo sources. With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel. Setting a value "0" in the middle is set to hear a sound. Sound is spread in left and right (the outside) so that the set value is made big. Please adjust by liking. Audyssey DSX™ ■ Soundstage ` -3dB to Reference to +3dB With this setting, you can adjust the soundstage when using Audyssey DSX™. Note • If the "Center" setting is set to "None", or both "Front High" and "Front Wide" settings are set to "None" (➔ 46), this setting cannot be selected. Theater-Dimensional ■ Listening Angle ` Wide: Select if the listening angle is 40 degrees. ` Narrow: Select if the listening angle is 20 degrees. With this setting, you can optimize the Theater-Dimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings. Front left speaker Front right speaker 20°/40° LFE Level ■ Dolby Digital*1, DTS*2, Multich PCM, Dolby TrueHD, DTS-HD Master Audio, DSD*3 ` -2dB, -20dB, -10dB, or 0dB With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for each input sources. If you find that low-frequency effects are too loud when using one of these sources, change the setting to -20 dB or -2 dB. *1 Dolby Digital and Dolby Digital Plus sources. *2 DTS and DTS-HD High Resolution Audio sources. *3 DSD (Super Audio CD) sources. Source Setup Items can be set individually for each input selector. Preparation Press the input selector buttons to select an input source. Main menu Source Setup Audyssey When Audyssey MultEQ® Room Correction and Speaker Setup is complete, the "Equalizer" (➔ 47) will be set to "Audyssey" and the "Dynamic EQ" will be set to "On". ■ Dynamic EQ ` Off: Audyssey Dynamic EQ® off. ` On: Audyssey Dynamic EQ on. The Dynamic EQ indicator will light (➔ 9). With Audyssey Dynamic EQ, you can enjoy great sound even when listening at low volume levels. Audyssey Dynamic EQ solves the problem of deteriorating sound quality as volume is decreased by taking into account human perception and room acoustics. It does so by selecting the correct frequency response and surround volume levels moment-by-moment so that the content sounds the way it was created at any volume level - not just at reference level. Note • If Pure Audio or Direct listening mode is selected, this setting cannot be selected. En 50