Onkyo TX-NR808 Owner Manual - Page 73
Controlling Zone 2/3 with the Remote, Controller, Adjusting the Volume for Zones, Muting Zones
View all Onkyo TX-NR808 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Controlling Zone 2/3 with the Remote Controller STANDBY ON ZONE INPUT SELECTOR Adjusting the Volume for Zones On the remote controller, press ZONE repeatedly, and then use VOL R/X. On the AV receiver, press ZONE 2 or ZONE 3 (the ZONE 2/3 indicator and Zone 2/3 selector on the display flashes) and press LEVEL followed by Up S/Down F within 8 seconds. Muting Zones Note • To control Zone 2/3, you must press the remote controller's ZONE first. • ZONE turns red while Zone 2 is on, and green while Zone 3 is on. 1 Press ZONE repeatedly, then point the remote controller at the AV receiver and press ON. Tip • The ZONE 2/3 12V TRIGGER OUT goes high (+12 V). 2 To select an input source for Zone 2/3, press ZONE repeatedly, followed by INPUT SELECTOR. To select AM or FM, press TUNER input selector and ZONE repeatedly. (North American models) You can also select SIRIUS. 3 To turn off Zone 2/3, press ZONE repeatedly, followed by STANDBY. Note • Only analog input sources are output by the ZONE 2/3 PRE OUT and FRONT WIDE/ZONE 2 L/R terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it's connected to an analog input. • You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that station will also be used in Zone 2. • When you connect Zone 2 speakers directly to the AV receiver, listening modes that require surround back speakers or front high speakers or front wide speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz Height, and Audyssey DSX™ are unavailable. • When the input selector of Zone 2/3 is selected, power consumption on standby mode slightly increases. • While Zone 2/3 is on, V functions will not work. On the remote controller, press ZONE repeatedly, and then press MUTING. To unmute a zone, on the remote controller, press ZONE, and then press MUTING again. Adjusting the Tone and Balance of Zones 1 On the AV receiver, press ZONE 2. 2 Press the AV receiver's TONE repeatedly to select "Bass", "Treble" or "Balance". 3 Use F/S to adjust the bass, treble or balance. • You can boost or cut the bass or treble from -10 dB to +10 dB in 2 dB steps. • You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps. Note • Zones can also be unmuted by adjusting the volume. • The Zone 2 volume, tone, and balance function have no effect on ZONE 2 PRE OUT when the "Zone2 Out" setting is set to "Fixed" (➔ 72). • The Zone 3 volume function has no effect on ZONE 3 PRE OUT when the "Zone3 Out" setting is set to "Fixed" (➔ 72). • Even if you repeatedly press the remote controller's ZONE to select zones, the last zone selection will be retained once you have switched to other components by pressing other REMOTE MODE after pressing ZONE. En 73