Panasonic PV GS300 Digital Video Camera - English/ Spanish - Page 15

Before using Power supply ª Charging the battery When this product is purchased, the battery is not charged. Charge the battery before using this product. ≥Battery charging time (-16-) ≥We recommend using Panasonic batteries. ≥If you use other batteries, we cannot guarantee the quality of this product. ≥If the DC Cable is connected to the AC adaptor, then the battery will not get charged. Remove the DC Cable from the AC adaptor. 1 Connect the AC Cable to the AC adaptor and the AC Jack. 2 Put the battery on the battery mount by aligning the mark, and then securely plug it in. 1 Connect the AC Cable to the AC adaptor and the AC Jack. 2 Connect the DC Cable to the AC adaptor. 3 Connect the DC Cable to this product. ≥The output plug of the AC Cable is not completely connected to the AC adaptor jack. As shown in 1, there is a gap. ≥Do not use the power cord for other equipment since the power cord is exclusively designed for this Camcorder. Do not use the power cord from other equipment for this Camcorder. ª Fitting the battery Push the battery against the battery holder and slide it until it clicks. ª Charging lamp Lights up: Charging Goes off: Charging completed Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up and normal charging will start. When the battery temperature is excessively high or low, the [CHARGE] lamp flashes and the charging time will be longer than normal. ª Connecting to the AC outlet ª Removing the battery While sliding the [BATT] lever, slide the battery (or the DC Cable) to remove it. BATT ≥Hold the battery with your hand so it does not fall. ≥Before removing the battery, be sure to set the [OFF/ON] switch to [OFF]. 1 15 LSQT0974