Panasonic UF 8200 Facsimile - Page 9

Precaution - drum

Page 9 highlights

ENGLISH Precaution ENGLISH For Your Safety „ The maximum power consumption is 1000 W. A properly wired (grounded), dedicated, 15A, 120V AC outlet is required. Do not use an extension cord. The power cord on this machine must be used to disconnect the main power. Please ensure that the machine is installed near a wall outlet and is easily accessible. Supplies „ Store the Toner Cartridge and paper in cool areas with low humidity. • Panasonic recommends using high quality 16 - 24 lb paper, using an inferior paper may cause excessive paper curl, requiring you to empty out the Output Tray more often to avoid paper jams. • When clearing a paper jam or other fault, follow the appropriate procedure given in this Operating Instructions. • For optimum performance, it is recommended that only Panasonic Brand supplies are used in the machine. • Certain types of transparency film may not be compatible and may damage your machine. Consult with an authorized Panasonic dealer for advice regarding non-standard paper types. (Panasonic has tested "3M CG3300" transparency film and found it to be compatible.) „ Use of other than genuine Panasonic supplies can damage the printer. Be sure to use only genuine Panasonic Toner Cartridge (UG-5570) designed for optimum performance. Average yield for the UG-5570 is approximately 10,000 pages (3% coverage). Note: Average yield is based on 3% coverage of the printable area with repetitive printing of 10 pages (Letter/ A4 size, single side printing, default density). The yield of a Toner Cartridge varies depending on the coverage, temperature, humidity, media, etc. Therefore, the average yield cannot be guaranteed. Continuously printing 10% coverage of printable area will reduce the yield of the Toner Cartridge to about half as compared to 3% coverage printing. The maximum yield of the Toner Cartridge will not exceed 11,500 pages. „ Dispose of Toner Cartridge and OPC Drum Unit(s) according to your local regulations. Installation „ The machine should not be installed in areas with the following conditions: • Extremely high or low temperature and humidity. Ambient conditions: Temperature: 50 - 86 °F Relative humidity: 30 - 80 % • Where temperature and humidity can change rapidly, causing condensation. • Direct exposure to sunlight. • In areas of high dust concentration. • In areas with chemical fume concentration. • With unstable or uneven conditions (floors, etc.). • Directly in the air conditioning flow. • In areas of poor ventilation. • In areas with extreme vibration. Illegal Copies It is unlawful to make copies of certain documents. Copying certain documents may be illegal in your country. Penalties of fines and/or imprisonment may be imposed on those found guilty. The following are examples of items that may be illegal to copy in your country. • Currency • Bank notes and checks • Bank and government bonds and securities • Passports and identification cards 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62

9
ENGLISH
ENGLISH
Precaution
For Your Safety
±
The maximum power consumption is 1000 W.
A properly wired (grounded), dedicated, 15A, 120V AC outlet is required. Do not use an extension cord.
The power cord on this machine must be used to disconnect the main power.
Please ensure that the machine is installed near a wall outlet and is easily accessible.
Supplies
±
Store the Toner Cartridge and paper in cool areas with low humidity.
Panasonic recommends using high quality 16 - 24 lb paper, using an inferior paper may cause excessive
paper curl, requiring you to empty out the Output Tray more often to avoid paper jams.
When clearing a paper jam or other fault, follow the appropriate procedure given in this Operating
Instructions.
For optimum performance, it is recommended that only Panasonic Brand supplies are used in the
machine.
Certain types of transparency film may not be compatible and may damage your machine.
Consult with an authorized Panasonic dealer for advice regarding non-standard paper types.
(Panasonic has tested "3M CG3300" transparency film and found it to be compatible.)
±
Use of other than genuine Panasonic supplies can damage the printer. Be sure to use only genuine
Panasonic Toner Cartridge (UG-5570) designed for optimum performance.
Average yield for the UG-5570 is approximately 10,000 pages (3% coverage).
Note:
Average yield is based on 3% coverage of the printable area with repetitive printing of 10 pages (Letter/
A4 size, single side printing, default density). The yield of a Toner Cartridge varies depending on the
coverage, temperature, humidity, media, etc. Therefore, the average yield cannot be guaranteed.
Continuously printing 10% coverage of printable area will reduce the yield of the Toner Cartridge to
about half as compared to 3% coverage printing. The maximum yield of the Toner Cartridge will not
exceed 11,500 pages.
±
Dispose of Toner Cartridge and OPC Drum Unit(s) according to your local regulations.
Installation
±
The machine should not be installed in areas with the following conditions:
Extremely high or low temperature and humidity.
Ambient conditions:
Temperature: 50 - 86
°
F
Relative humidity: 30 - 80 %
Illegal Copies
It is unlawful to make copies of certain documents.
Copying certain documents may be illegal in your country. Penalties of fines and/or imprisonment may be
imposed on those found guilty. The following are examples of items that may be illegal to copy in your
country.
• Currency
Bank notes and checks
Bank and government bonds and securities
Passports and identification cards
Where temperature and humidity can change rapidly, causing condensation.
Direct exposure to sunlight.
In areas of high dust concentration.
In areas with chemical fume concentration.
With unstable or uneven conditions (floors, etc.).
Directly in the air conditioning flow.
In areas of poor ventilation.
In areas with extreme vibration.