Philips 32PFL3504D User manual - Page 13

Switch on and Set Up the TV Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press . on the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the first time you turn on the TV. Initial Setup Select your menu language. Seleccione el idioma para el menú. Sélectionnez la langue du menu. English Español Français Select OK OK MENU Skip Follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 10 minutes. Press Í or Æ to select the desired mode for energy saving, then press OK. Initial Setup Select "Retail" or "Home" for your location. Retail Home Select SETUP OK OK Exit Select [Retail] if you want backlight to be brighter. Select [Home] to reduce the power consumption. • Select [Retail], the unit will be set up with predefined setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR® qualification. • Select [Home], the unit is set to maximize the energy efficiency for home setting and it can be adjusted through a choice of picture and sound quality according to your preference. Press OK to begin [Settings Assistant]. Settings assistant Settings assistant helps you customize picture settings. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/ Right keys. OK Next BACK Back MENU Exit Press Í or Æ 5 times to select the side of the pictures that is the most pleasing to you. then press OK. Left side Right side 1/5 Select the picture setting that you prefer. Select OK Next BACK Back MENU Exit Press OK to finish [Settings assistant]. Settings assistant You have set up your viewing preferences. OK Store Finish the Setup. BACK Back MENU Exit Note • If you connect the cable system directly, contact the CATV installer. • If you press . or MENU during autoprogram, this setting will be canceled. • The initial autoprogram function can be executed for either [Antenna] or [Cable] only once.When you change the connection (Antenna/Cable), set autoprogram again. (Refer to page 24.) • If there is no signal input from the antenna terminal and no operation for several seconds after you turn on the TV, [Helpful Hints] appears. Follow the instructions listed on the TV screen. 12 EN