Pioneer VSX-933 Instruction Manual English - Page 101
as Subnet Mask and Gateway
View all Pioneer VSX-933 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Network • When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting automatically. ("Enable" is set by default.) To assign fixed IP addresses to each components, you must set "DHCP" to "Disable" and assign an address to this unit in "IP Address" as well as set information related to your LAN, such as Subnet Mask and Gateway. Setting Item Wi-Fi Wi-Fi Setup Wi-Fi Status MAC Address DHCP IP Address Subnet Mask Gateway DNS Server Default Value Off(Wired) - Enable 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 Setting Details Connect the unit to network via wireless LAN router. "On": Wireless LAN connection "Off (Wired)": Wired LAN connection • When switching between "On" and "Off(Wired)", stop the Network service. Also, when group playback is in process, cancel the group playback once, and then switch the setting. You can configure wireless LAN settings by pressing ENTER when "Start" is displayed. The information of the connected access point will be displayed. "SSID": SSID of the connected access point. "Signal": Signal strength of the connected access point. "Status": Status of the connected access point. This is the MAC address of this unit. This value is specific to the component and cannot be changed. "Enable": Auto configuration by DHCP "Disable": Manual configuration without DHCP • If selecting "Disable", you must set "IP Address", "Subnet Mask", "Gateway", and "DNS Server" manually. Displays/Sets the IP address. Displays/Sets the subnet mask. Displays/Sets the gateway. Displays/Sets the primary DNS server. Setting Item Proxy URL Proxy Port Friendly Name Default Value 8080 Pioneer VSX933 XXXXXX Setting Details Displays/Sets the proxy server URL. Displays/Sets the proxy server port number when you enter "Proxy URL". Change the device name for this unit which is shown on other devices connected to the network to an easily recognized name. 1. P ress ENTER to display the Edit screen. 2. S elect a character or symbol with the cursors and press ENTER. Repeat it to input 31 or less characters. "A/a": Switches between upper and lower cases. (Pressing MODE on the remote controller also toggles between upper and lower cases Moves the cursor to the arrow direction. " ": Removes a character on the left of the cursor. " ": Enters a space. • Pressing CLEAR on the remote controller will remove all the input characters. 3. After inputting, select "OK" with the cursors and press ENTER. The input name will be saved. 101 Front Panel≫ Rear Panel≫ Remote≫