Pioneer VSX-933 Instruction Manual English - Page 89
Source, Dolby, Volume, Input Volume Absorber, Name Edit
View all Pioneer VSX-933 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Dolby Change the setting of when Dolby signals are input. Setting Item Loudness Management Default Value On Volume Change the Volume settings. Setting Details When playing Dolby TrueHD, enable the dialog normalization function which keeps the volume of dialog at a certain level. Note that when this setting is Off, the DRC function that allows you to enjoy surround at low volumes is fixed to off when playing Dolby Digital Plus/Dolby TrueHD. "On": When this function is used "Off": When this function is not used Setting Item Mute Level Default Value -∞dB Volume Limit Off Power On Level Last Headphone Level 0.0 dB Setting Details Set the volume lowered from the listening volume when muting is on. Select a value from "-∞dB", "-40dB" and "-20dB". Set the maximum value to prevent the volume from becoming too loud. Select a value from "Off", "-32 dB" to "+17 dB". Set the volume level of when the power is turned on. Select a value from "Last" (Volume level before entering standby mode), "-∞ dB", and "-81.5 dB" to "+18.0 dB". • You cannot set a higher value than that of "Volume Limit". Adjust the output level of headphones. Select a value between "-12.0 dB" and "+12.0 dB". Source Input Volume Absorber Adjust the volume level when there are differences in volume level among multiple devices connected to this unit. Select the input selector to make the setting. Setting Item Input Volume Absorber Default Value 0.0 dB Setting Details Select a value between "-12.0 dB" and "+12.0 dB". Set a negative value if the volume of the target device is larger than the others and a positive value if smaller. To check the audio, play back the connected device. • This function does not work in Zone 2. Name Edit Set an easy name for each input. The set name appears on the main unit's display. Select the input selector to make the setting. Setting Item Name Edit Default Value Input name Setting Details 1. S elect a character or symbol with the cursors, and press ENTER. Repeat this operation to input up to 10 characters. "A/a": Switches between upper and lower cases. (Pressing MODE on the remote controller also toggles between upper and lower cases Moves the cursor in the arrow direction. " ": Removes a character on the left of the cursor. " ": Enters a space. • Pressing CLEAR on the remote controller will remove all the input characters. 2. After inputting, select "OK" with the cursors, and press ENTER. The input name will be saved. • To name a preset radio station, press TUNER on the remote controller, select AM/FM, and select the preset number. 89 Front Panel≫ Rear Panel≫ Remote≫