ProForm 4.0 Rt Bike English Manual - Page 11

7. Orient the Upright (2) and the Top Shield (44) as shown. Slide the Top Shield upward onto the Upright. Have a second person hold the Upright (2) and the Top Shield (44) near the Frame (1) until step 8 is completed. Locate the wire tie in the Upright (2). Tie the lower end of the wire tie to the Main Wire (43) and to the Frame Pulse Wire (42). Next, pull the upper end of the wire tie until the Main Wire and the Frame Pulse Wire are routed through the Upright. Tip: To prevent the wires from falling into the Upright (2), secure the wires with the wire tie. 7 Wire Tie 44 2 Wire Tie 42 43 1 8. Tip: Avoid pinching the wires. Slide the Upright (2) onto the Frame (1). 8 Attach the Upright (2) with four M10 x 16mm Screws (75) and four M10 Split Washers (36). Tip: Tighten the two Screws in the front of the Upright, and then tighten the other two Screws. Slide the Top Shield (44) downward and press it onto the Left and Right Front Shields (13, 14). 44 36 13, 14 75 Avoid pinching the wires 75 2 36 1 11