ProForm 490 Le Elliptical English Manual - Page 12

13. Apply a small amount of grease to one of the Pedal Arm Axles (32). Next, slide an M8 Washer (88) and a Pedal Arm Cover (31) onto an M8 x 23mm Shoulder Screw (115), and turn the Shoulder Screw a few turns into the Pedal Arm Axle (32). While another person holds the front end of the Left Pedal Arm (14) inside the bracket on the Left Upper Body Leg (11), insert the Pedal Arm Axle (32) into both parts. Slide an M8 Washer (88) and a Pedal Arm Cover (31) onto another M8 x 23mm Shoulder Screw (115), and turn the Shoulder Screw a few turns into the Pedal Arm Axle. Tighten both Shoulder Screws. Repeat this step to attach the Right Pedal Arm (not shown) to the Right Upper Body Leg (12). 14. Lift the latch on the underside of the Left Pedal Arm (14), and set the Left Pedal Arm on the left Crank Bushing Sleeve (43). Release the lever, and make sure that the Left Pedal Arm (14) is securely connected to the Crank Bushing Sleeve (43). Connect the Right Pedal Arm (not shown) in the same way. See step 5. Tighten the M8 x 69mm Button Bolt (80) and the two M8 x 23mm Button Screws (84). 13 11 12 88 31 115 31 88 115 32 Grease 14 14 14 Latch 43 15. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical. 12