ProForm 490 Le Elliptical English Manual - Page 8

5. While another person holds the Upright (3) near the Base (1), connect the Upper Wire 5 Harness (48) to the Lower Wire Harness (49). Tip: Avoid pinching the wires. Insert the Upright (3) into the Base (1). Attach the Upright with an M8 x 69mm Button Bolt (80), an M8 Split Washer (90), and an M8 Jam Nut (79). Do not tighten the Button Bolt yet; make sure that the Jam Nut is in the hexagonal hole in the Base. Next, finger tighten two M8 x 23mm Button Screws (84) and two M8 Split Washers (90) into the Base (1). Do not tighten the Button Screws yet. Attach the Water Bottle Holder (22) to the Base (1) with two M4 x 16mm Blunt Screws (104). Avoid pinching the wires 80 90 90 84 3 48 49 79 90 84 104 1 22 6. Identify the Left Upright Cover (17), which is marked with a "Left" sticker, and hold it 6 against the left side of the Upright (3). Attach the Left Upright Cover (17) with two M4 x 16mm Round Head Screws (101). Attach the Right Upright Cover (39) in the same way. 17 101 3 39 101 8