RCA CC4352 User Guide - Page 52

Playback Playback Operation 1. Set the CH3/CH4 switch on the RF output adapter to channel CH3 or CH4. 2. Turn on the TV, and tune it to the same channel you selected with the RF output adapter's CH3/CH4 switch. 3. Press and hold the small red button on the CAMERA/OFF/VCR switch while you set it to VCR. 4. Press PLAY on the camcorder. • Turn the volume control on the monitor down all the way to prevent picture distortion. • During playback, use the playback features described on pages 44-45. 5. Press STOP/EJECT on the camcorder when you are finished. Viewing What the Camcorder Is Recording 1. Turn on the TV and tune it to channel 3 or 4. Turn the TV's volume down to prevent a high-pitched squeal caused by feedback. 2. Set the CH3/CH4 switch on the RF output adapter to the same channel you selected on the TV. 3. Press and hold the small red button on the CAMERA/OFF/VCR switch while you set it to CAMERA. 4. Press the REC/PAUSE button to begin recording. You can watch what the camcorder is seeing (or recording) on the TV screen. Normal TV Viewing For normal TV viewing, leave the RF output adapter hooked up to the TV. Disconnect the adapter's plug from the camcorder or turn the camcorder's power off. Note to Cable TV Installer This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. 49