Ricoh 3045 Fax Guide - Page 151

Sub Transmission Mode F Press [OK] twice. The standby display appears. G Specify a destination, and then press the {Start} key. Note ❒ If the fax is not received normally, "Error" appears in the Result column. ❒ Only the last 50 communications appear in the Journal. If you do not re- 2 ceive a reception notice message before the last 50 communications are fin- ished, "OK" might not be printed in the Journal's Result column. This may happen even if the mail is received normally at the other end. ❒ If you specify mailing list addresses, do not set for Reception Notice. Otherwise, you will receive multiple reception notice messages from e-mail recipients, and the Result column will be overwritten each time a new notice message is received. However, if you receive a reception notice message indicating an error, "Error" appears in the Result column and will not be overwritten, even if you subsequently receive a reception notice message as "OK" following the error message. ❒ Reception notice results are only shown in the Journal. The Result column in all other files, lists, and transmission reports show "--". ❒ Reception notice messages themselves are not recorded in the Journal. ❒ You can select whether or not to print the Reception Notice. This can be set with User Parameters (switch 21, bit 0) in the Facsimile Features menu. ❒ You cannot broadcast e-mail using Reception Notice. The documents are sent to the destinations in the order in which they were specified. Reference p.113 "Sender Settings" "Facsimile Features", General Settings Guide 141