Ricoh Aficio SP 1200SF Quick Installation Guide - Page 8

19 To reduce the risk of fire, electric shock and injury to people, note the following:  DO NOT use this product near appliances that use water, a swimming pool or in a wet basement.  DO NOT use the machine during an electrical storm (there is the remote possibility of an electrical shock) or to report a gas leak in the vicinity of the leak.  Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions. 20 Caution - To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord. 6 Regulations IEC 60825-1:2007 Specification This machine is a Class 1 laser product as defined in IEC 60825-1:2007 specifications. The label shown below is attached in countries where required. CLASS 1 LASER PRODUCT LASER KLASSE 1 PRODUKT This machine has a Class 3B Laser Diode which emits invisible laser radiation in the Scanner Unit. The Scanner Unit should not be opened under any circumstances. Laser Diode Wave length: 780 - 800 nm Output: 10 mW max. Laser Class: Class 3B Warning Use of controls, adjustments or performance of procedures other than those specified in this manual may result in hazardous radiation exposure. Disconnect device This product must be installed near an AC power outletelectrical socket that is easily accessible. In case of emergencies, you must disconnect the power cord from the AC power outletelectrical socket to shut off power completely. Wiring information (U.K. only) If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362 with the same rating as the original fuse. Always replace the fuse cover. Never use a plug that does not have a cover. If in any doubt, call a qualified electrician. Warning - This printer must be earthed. The wires in the mains lead are coloured in line with the following code:  Green and Yellow: Earth  Blue: Neutral  Brown: Live Radio interference This product complies with EN55022 (CISPR Publication 22)/Class B. When connecting the machine to a computer, ensure that you use the following interface cables. A USB cable which must not exceed 2.0 metres in length.